Z Countertop Square Edge Form
Z Countertop Square Edge Form
Front Form - each form is 90 inches (2286mm) per length.
Available in either Full pack containing 8 x lengths Front edge + 8 x lengths of back edge per box, or 1/2 pack containing 4 lengths of each
This form creates a sharp clean square edge profile, an ideal option for modern kitchens where a streamlined aesthetic is required.
The Z Countertop forms are designed to be attached to the cement board, which is screwed onto the top of the cabinets. The Z Countertop forms are simply snapped off when the concrete is cured, leaving behind the decorative edge benchtop surface.
Creates a 57mm height edge to the cast-in-place concrete benchtop.
Easy to use Cut to a custom length
Cast-in-place concrete forms
Clean cuts allow edges to align tightly
No wooden framing required
No heavy lifting
Available in Individual lengths:
Front Form
90” (2286mm)
Limited amount of other styles available. Please contact us to see what we have available.
-
To use - place a 9mm plywood sheet and a 6mm fibre cement board on top of the cabinets carcass. The cement boards should be cut flush to the edge of the cabinets. The forms will then be screwed into the cement board with 12mm x 10g Panhead screws. After the concrete is poured, the forms are snapped off along the designated 'breakpoint' to reveal a beautiful clean edge.
-
Concrete benchtops that are made with rebar that is too large in scale for the slab thickness are susceptible to telegraph cracking.
When concrete shrinks due to drying out, high tensile stress levels develop around proportionally oversized reinforcing. These stresses cause cracks that run along the length of the steel. Smaller diameter reinforcing has less of an effect on the concrete, so the same amount of concrete shrinkage develops much less tensile forces, thus the likelihood of cracks caused by the steel itself drops dramatically.
Because all concrete shrinks to some degree and shrinkage occur over a long period of time, the occurrence of telegraph cracking may not appear until long after a countertop is installed.
Our recommendation is use a fibreglass based composite scrim or bar instead to prevent rust issues, ghosting and telegraph cracking.
